| |
- Throw lid first.
- Throw a sturdy knob so you can lift into opening of
container to measure without using calipers
Tip: Don’t let the two wet pieces touch or
they may stick together.
- When leather hard make a pin tool hole in knob to allow
air to
escape.
|
|
Double flange
- Throw lid first.
- Throw a sturdy knob so you can lift into opening of
container to measure without using calipers.
Tip: Don’t let the two wet pieces touch or
they may stick together.
- Measure container in two places.
Tip: Be very careful in your measurements.
- When leather hard make a pin tool hole in knob to allow
air to escape.
|
|
- Throw the base of this covered container first.
- Keep the lip thick so you can make the flange.
- Measure inside rim with calipers
- Next, make flat lid, measuring the outside edge with
calipers so they will fit.
Tip: Cut a channel into knob to let air
escape.
|
|
- Throw lid first.
- Throw a sturdy knob so you can lift into opening of
container to measure without using calipers.
Tip: Don’t let the two wet pieces touch or
they may stick together.
- Measure container in two places.
Tip: Be very careful in your measurements.
- When leather hard make a pin tool hole in knob to allow
air to escape. Double flange
|
|
- Throw lid first.
- Start lid like a bow.
- Push top edge toward center to create a flange.
- Measure with calipers right away.
- Use that measurement to measure inside lip of the
covered container.
Tip: Throw lid upside-down. Trim right side up
when leather hard.
|
|
|
